Onicon D-1400 Manual de usuario descargar pdf (Pagina 7)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

D-1400 Portable Metereing System Manual 05/14 - 0722-2 Page 7

1.4 ADDITIONAL REQUIRED HARDWARE

Flow Meter

ONICON offers a wide variety of ow meters to satisfy most liquid, gas and steam

metering applications. Please refer to ONICON’s ow meter literature, or consult

ONICON or your local representative for help in selecting the ow meter that will best

t your requirements.

1.5 WORKING ENVIRONMENT

The D-100 was designed for installation and use in typical industrial environments that are

free of corrosive liquids and fumes, direct liquid exposure, heavy condensation, temperature

extremes, direct sunlight, and vibrations. The operating ambient air temperature range is -20° F

to 140° F. Electrical power should be relatively clean, free of high frequency noise, large voltage

transients, and protected from power surges and brown-outs.

1.6 WARRANTY & SERIAL NUMBER

Warranty

ONICON’s 2-year “No-fault” warranty reduces start-up costs by extending coverage for

incidental damage during installation. Certain exclusions apply. Please refer to ONICON’s

Conditions of Sale for details.

Serial Number

The serial number of your D-100 is located outside and inside the enclosure. Also located

inside the enclosure is a label with the serial number of the associated ONICON ow

meter or sensor your D-100 was intended to be used with. The serial numbers are unique

identiers that you should have available when contacting ONICON for assistance

regarding the installation or use of this product.

SECTION: 2.0 SYSTEM OPERATION AND SET-UP

2.1 SYSTEM OPERATION

The D-1401 and D-1402 Display Module LCD display shows the ow

rate as a number representing the frequency output signal, in Hertz,

from the ow meter.

The D-1401 Display Module shows the frequency output signal of the

single turbine from the F-1100.

The D-1402 Display Module shows the averaged output from both

turbines. This system also has the capability of displaying the

individual output from the top or bottom turbine by using the

selection switches on the Display Module.

This frequency output is then converted to gallons per minute for the

pipe size being measured via the laminated conversion chart included

with the system.

Please contact ONICON to obtain conversion factors for any pipe

sizes not listed on the chart, or if you require a ow rate unit of

measure other than gallons or liters.

1 2 3 4 5 6 7 8 9 10 11 12 ... 28 29

Sin comentarios

Onicon D-1400 Manual de usuario Pagina 7