Onicon F-1100 Series Manual de usuario descargar pdf (Pagina 4)

11451 Belcher Road South, Largo FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

Turbine Flow Meter Manual 05/14 - 0721-3 / 13518 Page 4

SECTION 1.0: INTRODUCTION

We, at ONICON Incorporated, would like to thank you for purchasing our quality, U.S. made, Turbine

Flow Meter. As our valued customer, our commitment to you is to provide fast reliable service and

assistance, while continuing to offer you new products to meet your growing ow measurement needs.

1.1 PURPOSE OF THIS GUIDE

We have written this guide to provide the persons responsible for the installation, operation and

maintenance of your turbine ow meter with the most specic equipment information they will

need. This is NOT an electrical or plumbing trade manual.

WARNING

Please do not permit any persons to install, operate or maintain this equipment unless they have a

complete knowledge of their trade skills and are competent to work on high pressure hot and cold

water systems, according to their individual trades. Death or permanent injury may result from

accidents with these systems.

This guide is the basic reference tool for all ONICON Turbine Flow Meters. If you have not

purchased all of the options, there will be references in this manual which are not applicable to

your meter(s).

1.2 TYPICAL TURBINE FLOW METERS

ONICON’s Turbine Flow Meters measure the velocity

of owing liquids by counting the frequency at

which the blades of a rotating turbine pass a xed

electrode. Circuitry within the ow meter electronics

enclosure then converts the rotational rate to digital

and/or analog signals which are transmitted via

a connecting cable to any of ONICON’s display

devices, BTU meters and/or a data acquisition

system.

Sweat or NPT

Process Connections

Electronics Enclosure

Inline Meter

Insertion Meter

1 2 3 4 5 6 7 8 9 ... 52 53

Sin comentarios

Onicon F-1100 Series Manual de usuario Pagina 4