Onicon System-10 BACnet Manual de usuario descargar pdf (Pagina 16)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

System-10-BAC Network Interface Installation Guide 04/14 - 0652-8 / 16957 Page 16

8. When the address change is complete, the following message will appear. You

must cycle power to the System-10 for the change to take effect.

1.6.3 Changing the Gateway Address

Changing the gateway address requires the use of RUInet utility software and a PC with

an Ethernet card and an available port. Assuming the display is programmed with the

default address (192.168.1.24) the host PC must be congured to operate with an

IP address of 192.168.1.1 and a subnet mask of 255.255.255.0. RUInet is available for

download from the ONICON web site, www.onicon.com.

1. Load RUInet and congure the PC as necessary.

2. Connect an Rj45 Ethernet cable between the PC and the display and power the

System-10. Allow 60 seconds for the display rmware to cycle through start-up

diagnostic routines.

3. Open RUInet.

4. From the Remote User Interface main menu (shown below) select option “I”,

Change IP Address.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 26 27

Sin comentarios

Onicon System-10 BACnet Manual de usuario Pagina 16