Onicon System-10 Dualnet Manual de usuario descargar pdf (Pagina 10)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

System-10 Dual Network Interface Installation Guide 05/14 - 0972-1 Page 10

Powered Pulse:

This type of output refers to a pulse which has an associated voltage with it (see Fig. 2).

Set the selector switch, S1 to Pwrd Pulse. The allowable voltage range is 5-24 VDC. The

input impedance is set at the factory to be 11 KOHM via the impedance selector jumper

(J1, see Fig. 1). A lower impedance, 3 KOHM can be selected if required by the instrument

providing the pulse output. Consult the instrument manufacturer or ONICON if you are

uncertain as to the proper jumper selection.

Fig. 2

Open Collector (Sourcing):

This type of output refers to an open Collector Switch congured for a sourcing function

(see Fig. 3). Set the selector switch, S1 to SRC. The switch must be rated for at least 20mA

at 20VDC.

Fig. 3

Di3 In (+)

Di3 In (-)

Di3 In (+)

Di3 In (-)

ONICON

BTU Meter

ONICON

BTU Meter

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Sin comentarios

Onicon System-10 Dualnet Manual de usuario Pagina 10