Onicon System-30 BTU Manual de usuario descargar pdf (Pagina 18)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

System-30 BTU Measurement System Manual 05/14 - 0667-2 / 18335 Page 18

3.3.3 Isolated Analog Output (Optional):

The System-30 may be ordered from the factory with an optional analog output. This

output is factory congured to provide a linear output proportional to any one of the

following operating parameters: ow rate, energy rate, internal temperature sensor,

external temperature sensor or delta temperature. The format of this output may be

selected to provide a 4-20 mA, 0-10 Volt or 0-5 Volt signal.

This selection is eld congurable using the jumpers located on the analog output board

as shown below. Changing any of the displayed units or multipliers will affect the analog

output. If any unit or multiplier values are changed at the System-30 BTU Meter, the

analog output value will also be changed. If you are unsure of the ramications of any

changes you are contemplating, please contact ONICON for assistance.

4-20mA

0-5 Volt

0-10 Volt

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 30 31

Sin comentarios

Onicon System-30 BTU Manual de usuario Pagina 18