Onicon D-100 BACnet Manual de usuario descargar pdf (Pagina 17)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

D-100 Display Module BACnet Installation and Operation Guide 05/14 - 0635-6 / 18341 Page 17

1.6.3 Changing the Gateway Address

Changing the gateway address requires the use of RUInet utility software and a PC with

an Ethernet card and an available port. Assuming the display is programmed with the

default address (192.168.1.24) the host PC must be congured to operate with an

IP address of 192.168.1.1 and a subnet mask of 255.255.255.0. RUInet is available for

download from the ONICON web site, www.onicon.com.

1. Load RUInet and congure the PC as necessary.

2. Connect an RJ45 Ethernet cable between the PC and the display and power the

D-100. Allow 60 seconds for the display rmware to cycle through start-up

diagnostic routines.

3. Open RUInet.

4. From the Remote User Interface main menu (shown below) select option “I”,

Change IP Address.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 28 29

Sin comentarios

Onicon D-100 BACnet Manual de usuario Pagina 17