Onicon D-100 BACnet Manual de usuario descargar pdf (Pagina 6)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

D-100 Display Module BACnet Installation and Operation Guide 05/14 - 0635-6 / 18341 Page 6

1.4 NETWORK SIGNAL CONNECTIONS

1.4.1 BACnet MS/TP

BACnet MS/TP, 2-wire (half-duplex) serial output connections are connected to terminal

T1 as shown. Do not exceed 4.4 in-lb (0.5 Nm) of torque when tightening.

Terminal

Do not connect

shields to this

terminal.

CAUTION

Only qualied service personnel should make connections between the D-100 Flow Display

and the user’s external equipment. ONICON assumes no responsibility for damage caused to

the external equipment as a result of an improper installation.

CAUTION

Incoming and outgoing RS485 cable shield wires should be connected together, but must not be

connected to the display.

1 2 3 4 5 6 7 8 9 10 11 ... 28 29

Sin comentarios

Onicon D-100 BACnet Manual de usuario Pagina 6