Onicon System-10 P1 Manual de usuario descargar pdf (Pagina 8)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax +1 (727) 442-5699 • [email protected]

System-10-P1 Manual 10/14 - 0656-9 / 18320 Page 8

SECTION 2.0: UNPACKING

The SYSTEM-10 is generally shipped in one package unless optional hardware or equipment is

ordered. (Thermowells may have been shipped in advance.) Notify the freight carrier (all products are

shipped insured) and ONICON if any items are damaged in transit.

NOTE: Flow meters are packed separately.

2.1 CHECKING THAT YOU HAVE RECEIVED EVERYTHING

• Standard Documentation

Enclosed with each SYSTEM-10 is a comprehensive documentation package that includes

the following items:

The SYSTEM-10 BTU Meter Installation and Operation Guide

The BTU Meter Certicate of Calibration

Please notify ONICON if any of these items are missing.

• The Main Unit

Remove the SYSTEM-10 from the shipping carton and inspect it for physical damage.

When you complete the external inspection, open the SYSTEM-10 main unit and remove

the plastic bag containing the temperature sensors. Inside the main unit there are at least

three circuit boards (the number may vary according to the options purchased). Ensure

that the boards and connectors are securely plugged into the mother board (Appendix

A-13). Please notify ONICON immediately if you nd any discrepancies.

• Temperature Sensors

Temperature sensors are shipped inside the main unit. Inspect the sensors and cables for

external damage. Each sensor should have a label attached with a serial number identical

to that found on the SYSTEM-10 main unit.

• Temperature Thermowells

Note that thermowells and installation hardware are frequently shipped in advance of the

meter(s). Otherwise, the standard thermowells and installation hardware are packed with

the main unit. Optional hot tap thermowells will be shipped in a separate box.

• The Flow Meter

The ow meter calibrated with this BTU meter came complete with an instruction manual.

Please refer to the ow meter instruction manual for detailed information regarding the

installation, commissioning, and operation of the ow meter.

Each BTU meter is calibrated to a specic ow meter and must be used together as a

system. If the ow meter and BTU meter were purchased together, the serial number on

the ow meter should match the serial number on the label mounted directly on the BTU

meter.

IMPORTANT NOTE

The ONICON System-10 BTU Measurement System is a custom calibrated system. Unless

specically noted in writing by ONICON, ALL COMPONENTS (Btu meter, ow meter, and

temperature sensors) share the same serial number and must be instaled together as a system.

Mixing components from different systems will result in signicant errors in calibration.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 66 67

Sin comentarios

Onicon System-10 P1 Manual de usuario Pagina 8