Onicon F-2600 Manual de usuario descargar pdf (Pagina 61)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]

F-2600 & F-2700 Vortex Flow Meter Manual 02/15 - 0808-7 / 19204 Page 61

3.3.4 Alarms Menu

Password

ENTER

Use

keys to access menus

Alarms

Relay Alarm 1

More >

ENTER

Run Mode

Relay Alarm 2

More >

Relay Alarm 3

More >

Alarm LOG

xx Files (ENTER)

Clear Alarm LOG?

YES or NO

<Measure> units

xxxx

Alarm File

Time

Date

(Press EXIT to return

to Alarm LOG.)

* see below

Physical Layer does not exist on Two Wire

Mass - Accessible via HART

None

Mass

Volume

Temp 1,2

Press

Density

Energy

None

Mass

Volume

Temp 1,2

Press

Density

Energy

None

Mass

Volume

Temp 1,2

Press

Density

Energy

<Mode>

None

HIGH Alarm (>)

LOW Alarm (<)

<Mode>

None

HIGH Alarm (>)

LOW Alarm (<)

<Mode>

None

HIGH Alarm (>)

LOW Alarm (<)

<Measure> units

Energy Meters Only

Example for Setting an Alarm

The following shows how to set Relay Alarm 1 to activate if the mass ow rate is greater

than 100 lb/hr. You can check the alarm conguration in the Run Mode by pressing the

⇑ ⇓ keys until Alarm (1) appears. The lower line displays the mass ow rate at which the

alarm activates. Note: All outputs are disabled while using the Set-up Menus.

First, set the desired units of measurement:

1. Use ⇐ ⇒ keys to move to the Units Menu (see to page 64).

2. Press ⇓ key until Mass Flow Unit appears. Press ENTER.

3. Press ⇓ key until lb appears in the numerator. Press ⇒ key to move the underline

cursor to the denominator. Press the ⇓ key until hr appears in the denominator. Press

ENTER to select.

4. Press ⇑ key until Units Menu appears.

Second, set the alarm:

1. Use ⇐ ⇒ keys to move to the Alarms Menu.

2. Press the ⇓ key until Relay Alarm 1 appears.

3. Press ⇒ key to access Measure selections. Press ENTER and use the ⇓ key to select

Mass. Press ENTER.

4. Press ⇒ key to select the alarm Mode. Press ENTER and use ⇓ key to select HIGH

Alarm. Press ENTER.

5. Press ⇒ key to select the value that must be exceeded before the alarm activates.

Press ENTER and use ⇑ ⇓ ⇐ ⇒ keys to set 100 or 100.0. Press ENTER.

6. Press the EXIT key to save your changes. (Alarm changes are always permanently

saved. Up to three relay alarm outputs are available depending on meter

conguration.)

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 130 131

Comentarios a estos manuales

Sin comentarios

Onicon F-2600 Manual de usuario Pagina 61

Comentarios a estos manuales

Relacionado con productos y manuales para Instrumentos de medición Onicon F-2600